www.njctw.com
1) Policy – Waste disposal management shall be taken special note to prevent hospital infection. – Infections wastes shall be managed, stored strictly and burned by a incinerator located at hospital site. 2) Waste Disposal Plan a)Classification – Medical wastes in hospital are classified as follows; Infections Waste Specially-controlled waste Organ, needle, etc. Industrial waste Rubber gloves, etc. General waste
Read More
Waste Incinerator Door: Side/Front Opening Door VS. Top Opening Door Things Side Loading Door Top Loading Door Suggestion Cost Affordable High expense Manufacture Tech. Easy A clutter tough Safty safe a lot more protected Burner Creating L/ I L Filling up hands-on huge door can be by Forklift Land job little big Ash door exact same with feeding door or
Read More
The incinerator shall be equipped with water injection nozzle connection. If the temperature in the primary chamber should rise too high (normal temperature between 300 and 800?C) during the operating time, the automatic water injection shall be activated to decease the temperature. The incinerator shall have the following features and facilities:- a- Fuel oil grade No. 2 (diesel
Read More
The incinerator shall be provided with a range of interconnecting ductwork between the thermal reactor outlet and the inlet of the chimney. This ductwork shall consist of refractory lined tubes and high temperature resistant tubes made from rolled sheet steel of minimum 3mm thickness, welded along the length. The standard chimney shall be made of carbon steel plates of
Read More
“PYROLYTIC” combustion, by controlling the gasification of waste The incinerator manufacturer must avoid the release of black smoke and fine dust, during the loadings. It shall be able to reduce the volume of wastes by 98%. It shall be able to hold emission in the second burn with gas residence of not less than 2 seconds. The incineration should
Read More
The incinerator to be fully assembled wired and logic function tested in the factory, prior to dispatch. – One high flue gas temperature indicator/alarm to provide an audio/visual warning in the event of high flue gas temperatures occurring in two stages:- First stage audible alarm, second stage incinerator shutdown, with one voltage free contact for connection to a
Read More
This equipment quality structural for kinds of site, like hospital, environmental department, animal cremation agencies, etc. HICLOVER Incinerator supply updated models with dual combustion chamber, mix-combustion chamber and smoke filter chamber with refractory lines, and the combustion chamber temperature up to 1200 deg C. Tools Technical Specifications Version YD-10C Image Feed Capability Common 40 kgs per feed Burning Price Typical
Read More
Incinerator Model A1500, Intro This design is big-scale pet cremation tools for huge pets. Construction is dual/double combustion chamber with 03 units oil/gas burner, batch load incineration equipment. Animal feed chamber is 1500Liters (Model: A1500). Primary & Secondary combustion chambers and included mix-combustion chamber, smoke filter chamber with firebrick and Refractory Concrete chamber. Batch load on the bottom of chamber.
Read More
Animal Crematory Burner Ability: Normal 80kgs per feeding Thing Spec Layout A900 Interior Measurements 120 x 90 x 85 CM Match for Family Pet Feline – – – – yes – Family pet – yes Pig – – small Cow – – no Key Product Checklist Key Burning Chamber Additional Burning Chamber Mix-Combustion Chamber Smoke Filter Chamber Burner Control Instance
Read More
This model is small-scale waste incineration equipment for small waste output. Construction is dual/double combustion chamber with 02 units oil/gas burner. Waste feed chamber is around 900Liters (0.9m3, YD-50). Primary & Secondary combustion chambers and included mix-combustion chamber. Waste load on the bottom of chamber. Incinerator panel control suit for local operation. Design YD-50 with wet scrubber Photo Burning Cost
Read More